<displayHangulFixedWidth> (Always Use Fixed Width for Hangul Characters)

This element specifies whether applications should assume that all characters in the Hangul Syllables Unicode sub range (character values between 0xAC00 and 0xD7FF) are of a single fixed width or shall use the characters widths defined by the font in use (typical for a proportional width font).

Typically, applications shall retrieve the character width for any character in a document from the associated font, allowing each character to be of its own width (a proportional width character). This element, when present with a @val attribute value of true (or equivalent), specifies that applications shall instead assume a single fixed width for all characters in the Hangul Syllables sub range, by reading the width of Unicode character 0x4E00 from the associated font and using that width for all Hangul characters (or, if that character is not present, the next available character in the font).

example:

The default presentation would have each of those characters using the widths defined by the font (the highlighting indicates that each character has its own width):

However, if this compatibility setting is turned on:

<w:compat>
  <w:displayHangulFixedWidth />
</w:compat>

Then all three characters are forced to the fixed width of character 0x4E00 from the font (or, in this case, the next available character), resulting in the characters in the font being forced to that fixed width, which results in the following output:

Notice from the highlighting that the characters have been compressed to the width of the single character and displayed at that fixed width. ]

Parent Elements

<compat>2.15.3.9)

Attributes

Description

<val> (On/Off Value)

Specifies a binary value for the property defined by the parent XML element.

A value of on, 1, or true specifies that the property shall be explicitly applied. This is the default value for this attribute, and is implied when the parent element is present, but this attribute is omitted.

A value of off, 0, or false specifies that the property shall be explicitly turned off.

<w:… w:val="off"/>

The @val attribute explicitly declares that the property is turned off. ]

The possible values for this attribute are defined by the ST_OnOff simple type (§2.18.67).

The following XML Schema fragment defines the contents of this element:

<complexType name="CT_OnOff">
	<attribute name="val" type="ST_OnOff"/>
</complexType>